Look PX question...

[yooper]

Do you seriously need an allen wrench to adjust the DIN on the heel piece of a PX 18? There is no posidrive head in there... Truthfully, it doesn't look like much of a hex either...

Am I crazy or did I get some defective binders? Both heels are like that.

[ACHTUNG]

They should have posidrive. Sounds like you may have some defective bindings.

[huge-go]

They should have posidrive. Sounds like you may have some defective bindings.

Nah, all the px heels have the hex thing to adjust the DIN.

[HankScorpio]

my px14s have a posi on the heels, its a bitch to turn it but its definitley a posi.

[PowTron]

PX 18's have the allen key...they are not defective.

[ACHTUNG]

Hmmm, my PX 18 and all my PX 14 have posidrive and hex in the heel.

[D(C)]

My Axial2 200s need an allen key on the heel...

[yooper]

Hmm... must be a fairly new thing. Not a bad idea, though... those things can be a bitch to turn up high.

[Shredhead]

My first gen. pairs have a posi drive, but they are a bitch to turn up. Perhaps that's why the switched to hex?

[El Chupacabra]

All the Pivot/ Axial bindings I have or have had (and there's been a lot) have had both the pozi and an allen key heel piece screw for the DIN setting (8mm IIRC).

All the PX/ Axial 2 bindings I have or have had (and there's been only a few) have also had both pozi and allen key, same as the old Pivot/ Axial.

I like the design, because it's hard to turn up the tension with the pozi -- much easier with the leverage of a big allen key.

[MickeysEars]

My px14 racing need an allen key for sure...they are a bitch to adjust too !